Instruction Manual

PPC-2000 User’s Guide Chapter 7: Specifications
Doc.# 30002-00 Rev 2.3 Watlow Anafaze 231
PPC-2010 Processor Specifications
Up to 32 PPCs may be connected on a network. The default
baud rate is 19200 and is configured via AnaWin3.
The processor module’s front panel has two serial
communications ports. Both Port 1 and Port 2 can be used with
either RS-232 or RS-485 connections. Each port’s baud rate,
network address and format are configured via the rotary
switch on the front panel.
The bottom panel includes a 50-pin SCSI connector and a 10-
28Vdc power connector.
The processor module has 48 built in digital I/O points. 24
points are outputs only: 22 of these are user configurable for
control, alarms, or logic program outputs and 2 are dedicated
to system status and the global alarm. The remaining 24 I/O
points are user-configurable as either inputs or outputs for
control, alarms, or logic.
Figure 7.2 PPC-2010 Front View
Serial Port 1
RS-485
Connector
Connector
RS-232
RS-485
Connector
Serial Port 2
Power / Error
LEDs
Rotary
Address Switch
Connector
RS-232