Instruction Manual

Chapter 2: Hardware Installation PPC-2000 User’s Guide
20 Watlow Anafaze Doc.# 30002-00 Rev 2.3
Figure 2.5 PPC-2030 Jumpers and Switches
PPC-2030 Jumper Settings
Each of the four analog outputs on the PPC-2030 may be
configured either as a voltage output or a current output. A
mixture of current and voltage outputs may be used on a
particular module. The jumpers only determine if the output
signal is current or voltage. The actual span of the signal is
software selectable. See Output Type in Channels on page 115
for the various analog output signal settings.
Locate Jumpers 1 through 4. Table 2.6 on page 21 describes the
analog output jumper configuration. Install the jumper in the
orientation shown in Figure 2.5.
ç
CAUTION! Incorrectly installing the jumper may damage the
PPC-2030 module.
. . .
. . .
Voltage
v
i
v
i
. . .
. . .
Position
Current
Position
Analog Output Jumpers
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
JU1
JU2
JU3
JU4
...
...
...
...
...
...
...
...
JU4 (Output 1)
Dip Switch
S1
JU3 (Output 2)
JU2 (Output 3)
JU1 (Output 4)
432
Single Phase
Quadrature
1
51
SV4
Counter Input Number
{Improve illustration. More like 2.6 and 2.7.}