Instruction Manual

PPC-2000 User’s Guide Chapter 2: Hardware Installation
Doc.# 30002-00 Rev 2.3 Watlow Anafaze 25
2. Align the 4 interconnect tabs and their related slots, as
well as the module expansion bus connector.
Figure 2.9 Assembled Modules Bottom View
Figure 2.10 Modules Bottom/Side View
3. Gently press the modules together while observing the
alignment of the tabs and slots, as well as the pins on the
expansion bus connector.
4. When the module is properly seated, close the module
latches on the processor by pushing the latch toward the
front of the module. The modules are properly locked when
there is a firm connection with no rocking or shifting.
5. Repeat these steps for any additional modules. When
there are no additional modules, install the right end cap
in a similar manner.
bottom
latch
(unlocked)
bottom
latch
(locked)
Front
Back
Module
Module
Tab
Slot
Module
bottom
latch
(unlocked)
Module
bottom
latch
(locked)