Instruction Manual

Chapter 2: Hardware Installation PPC-2000 User’s Guide
40 Watlow Anafaze Doc.# 30002-00 Rev 2.3
1.
The name is shown for the first PPC-2000 in the system. See Digital I/O on page
132 for a complete explanation of digital I/O names.
2.
Both count and frequency are measured for the pulse input. See Inputs on page
127 for an explanation of analog input names.
Connecting Digital Inputs
The PPC-2010 module can accept digital inputs. When the
resistance of an input device is 27 kOhm or greater, the input
is considered off by the PPC-2000. When the resistance is 1
kOhm or less, the input is considered on.
To install a switch as a digital input, connect one lead to the DC
Common input return on the TB50. Connect the other lead to
the desired digital input on the TB50. Refer to Table 2.10 on
page 39 for screw terminal numbering.
Use the Digital I/O parameters to configure digital inputs.
Refer to Digital I/O on page 132.
Digital Out 35 35 PPC1: Proc 0.0.35
Digital Out 36 36 PPC1: Proc 0.0.36
Digital Out 37 37 PPC1: Proc 0.0.37
Digital Out 38 38 PPC1: Proc 0.0.38
Digital Out 39 39 PPC1: Proc 0.0.39
Digital Out 40 40 PPC1: Proc 0.0.40
Digital Out 41
SDAC Out 41
41 PPC1: Proc 0.0.41
Digital Out 42
SDAC Out 42
42 PPC1: Proc 0.0.42
Digital Out 43
SDAC Out 43
43 PPC1: Proc 0.0.43
Digital Out 44
SDAC Out 44
44 PPC1: Proc 0.0.44
Digital Out 45
SDAC Out 45
45 PPC1: Proc 0.0.45
Digital Out 46
SDAC Clock
46 PPC1: Proc 0.0.46
Global Alarm 47 PPC1: Proc 0.0.47
CPU Watchdog 48 PPC1: Proc 0.0.48
Com (DC Common for
Input Return)
49,50 N/A
Module I/O Number
TB-50
Terminal
AnaWin3 Name
(Dig I/O Spreadsheet)
1