Instruction Manual

Chapter 2: Hardware Installation PPC-2000 User’s Guide
56 Watlow Anafaze Doc.# 30002-00 Rev 2.3
EITB Connections
Table 2.15 and Table 2.16 indicate the encoder connections to
the EITB connected to the Encoder In Analog Out module.
Table 2.17 on page 57 lists the terminals that carry power.
Figure 2.40 PPC-EITB-1
Table 2.15 Encoder Connections to the EITB
Connected to J3 on the PPC-2030
Table 2.16 Encoder Connections to the EITB
Connected to J4 on the PPC-2030
1.
The AnaWin3 name is shown for the Encoder In Analog Out module with address
11 on the first PPC-2000 in the system. See Inputs on page 127 for a full
explanation of Analog input naming. Both count and frequency are measured for
each input.
Module
I/O Number
EITB Terminal AnaWin3 Name
(Input
Spreadsheet)
1
Phase 1 Phase 2
+-+-
Count 1
Frequency 1
2345
PPC1:EIAO 11.1.1 C
PPC1:EIAO 11.2.1 F
Count 2
Frequency 2
8 9 10 11
PPC1:EIAO 11.1.2 C
PPC1:EIAO 11.2.2 F
Module
I/O Number
EITB Terminal AnaWin3 Name
(Input
Spreadsheet)
1
Phase 1 Phase 2
+-+-
Count 3
Frequency 3
2345
PPC1:EIAO 11.1.3 C
PPC1:EIAO 11.2.3 F
Count 4
Frequency 4
8 9 10 11
PPC1:EIAO 11.1.4 C
PPC1:EIAO 11.2.4 F
pin 1
pin 12
J2