TM AM-160-SE VM-160-SE Slim Li-ion Battery with LED and 3-Stud or V-Mount Thank you for choosing Watson Pro Please read this user manual carefully, and keep it for reference before using the battery.
SAFETY INSTRUCTIONS Make sure the battery is fully charged before use. When not in use, remove the battery from its device. Some electronic equipment will draw current even when the switch is off. Do not short-circuit the terminals. This battery is protected with an internal self-resetting fuse, but short circuits may still cause severe damage to the battery. Do not attempt to open the battery case under any circumstances. Do not remove the battery from any equipment that is powered on.
OVERVIEW PRODUCT FEATURES 1 Battery-level LED meter 1. Shows the remaining battery capacity. When the capacity reaches less than 9%, the bottom LED will flash. 2 Battery-level check button 2. 3 V-Mount/3-stud mount 1. interface 4 D-tap port 2. 12 V, 10 A max. Five-segment battery-level indicators for real-time monitoring of remaining battery capacity. Built-in D-tap connector powers your camera accessories.
SPECIFICATIONS Mount Type VM-160-SE: V-Mount AM-160-SE: 3-stud mount Chemistry Lithium-ion Capacity 158 Wh / 11 Ah Output Voltage 14.4 V Maximum Load 150 W / 12 A Average Runtime Approx 4 hr. at 35 W Accessory Port D-tap D-Tap Output 12 V / 10 A (max) Dimensions (H × W × D) 6 × 3.7 × 2.2 in. (15.2 × 9.5 × 5.6 cm) Weight 2.5 lb. (1150 g) Watson Pro is a registered trademark of the Gradus Group. © 2018 Gradus Group LLC. All Rights Reserved. www.poweredbywatson.com TM www.gradusgroup.