User's Manual

SET HOUSE ID
All Miro wireless devices installed in the same home must acquire the same
unique House ID before use. This process is known as house binding. Each Miro
wireless device is bound to all other Miro wireless devices in the house.
New Installation
1. With all devices installed and energized, make sure that every Miro wireless
device LED is yellow. If any LED is off, be sure the circuit breaker is on and
the device is correctly installed.
2. Press
on any device paddle
until the LED fl ashes yellow (about
2 seconds). This indicates that it has
acquired a unique House ID.
3. Make sure that all other Miro
wireless device LEDs are fl ashing
green, indicating that they have
acquired the same House ID.
4. Return to the device used in step 2, which is still fl ashing yellow. Press
until the LED changes to solid green (about 2 seconds). All device LEDs in
the house change to solid green, indicating house binding is complete.
Adding a Device to an Existing Installation
If you’re adding or replacing a device in a Miro wireless installation that is
already operating, the new device must acquire the same House ID as the other
Miro wireless devices in the house. After the new device is powered up, the LED
should be solid yellow. This indicates that it has not yet acquired a House ID. To
acquire the House ID for the existing system:
1. Press on any previously bound device until the LED flashes yellow (about
2 seconds).
2. Verify that the newly added device LED is flashing green, indicating that it
has acquired the House ID.
3. Return to the same previously bound device used in step 1 and press
until the LED changes to solid green (about 2 seconds). All device LEDs
should now be solid green.
Fluorescent Setup
If the dimmer will operate 2-wire fluorescent or compact fluorescent loads,
a special configuration step is required; if not, skip ahead to “Operation.”
1. Press and hold
until the LED flashes yellow (about 2 seconds).
2. Press the top of the device paddle
until LED briefly flashes red.
When you see
in the instructions,
firmly press and
hold both the top
and bottom of the
device paddle until
the LED changes
(about 2 seconds).
ii_DRD40_10346r2 090209.indd 7ii_DRD40_10346r2 090209.indd 7 2/10/2009 3:05:41 PM2/10/2009 3:05:41 PM