User's Manual

3
FSP-321B CONFIGURATION
The configuration process establishes the appropriate parameters for the FSP-321B operation. This is done through the FSBT mobile
application with Andriod version 4.3 or higher and iOS. If no configuration steps are taken, the sensor will use its default parameter
values.
USING THE FSBT CONFIGURATION SOFTWARE
The FSBT Bluetooth Configuration Software is a mobile app for changing defaults and testing of the FSP-321B. It provides wireless
access to the FSP-321B sensors for parameter changes and testing.
The FSBT display shows menus and prompts to lead you through each process. The mobil app provides a simple way to navigate
through the customization fields.
Within a certain mounting height of the sensor, the FSBT allows modification of the system without requiring ladders or tools.
The FSBT allows bi-directional communication between the FSP-321B and the FSBT configuration app . Simple menu screens let you
see the current status of the sensor and make changes. It can change FSP-321B sensor parameters such as high/low mode, sensitivity,
time delay, cut off and more. With the FSBT you can also establish and store FSP-321B parameter profiles.
Add QR code for app download
TROUBLESHOOTING
Lights will not go to High Mode:
• Check all wire connections and verify the load and the ground wires are tightly secured.
• Make sure that the sensor is not obstructed.
• Check light level parameter, to find out the amount of light that the sensor is detecting. Cover the sensor lens to simulate darkness
in the room. If the lights come ON, the setpoint needs to be adjusted. If set for minimum, more than 1 fc at the sensor of ambient
light will cause
the lights to be held OFF. See the new settings section for instructions.
• If lights still do not turn ON, call 800.879.8585 for technical support.
Lights will not go into Low Mode:
• The time delay can be set from a minimum of 30 seconds to a maximum of 30 minutes. Ensure that the time delay is set to the
desired delay and that there is no movement within the sensor’s view for that time period.
• To quickly test the unit operation, enable test mode and move out of the sensor’s view. Lights should fade to low mode after 5
seconds.
• If lights still do not fade to Low Mode, call 800.879.8585 for technical support
Lights will not turn OFF:
• Cut Off time may be set to “Disable.”
• Ensure that the Cut Off is set to the desired time and that there is no movement within the sensor’s view for that time period when
the lights are in Low Mode.
• To quickly test the unit operation, enable test mode and move out of the sensor’s view. Lights should fade to low mode after 5
seconds and the OFF (if cut off is enabled) after 10 sec.
• If lights still do not turn OFF, call 800.879.8585 for technical support.
NAVIGATION
Navigation is achieved by selecting any of the desired parameters.
Settings can be changed via number inputs or sliders.
NOTE: When you change parameter values on the FSP-321B,
you need wait about 3 minutes before the new parameters
are saved into the memory.
BLE COMMUNICATION
The FSBT app has the ability to
detect multiple sensors based on
signal strength or distance.
Every time the commissioning tool
establishes communication with the
FSP-321B, the controlled load will
cycle.