Owner Manual

Page 6
INSTALLATION
Top Mount Twist Faucet Installation
NOTICE
The faucet being used is an air-gap faucet, but is being used
for this non air-gap installation. The red and black color
coded ports on the faucet will remain unused. ONLY the blue
port will be used.
This RO Faucet is equipped with quick-connect fittings for easy tube instal-
lation. Refer to the guide on Page 2 for more information on how to use
these type of fittings.
Connect the Tubing
Step 5 Locate the 1/4” tube that is already connected to the filter lid,
labeled “Faucet”) and connect to the 1/4” blue quick-connect
fitting at the bottom of the faucet. Make sure the tube is inserted
the full 3/4” into the fitting.
Mount the faucet
NOTICE
A 1.25” mounting hole is required for faucet installation
Step 6 Make sure the Locking Tabs are “tucked”. Feed the tubes and
the lower faucet assembly through the mounting hole in the sink.
Test fit faucet placement.
Step 7 Make sure the lower faucet assembly is seated properly inside of
the rubber washer groove
NOTE: Arrow on base indicates FRONT of faucet.
Step 8 Using a Phillips screwdriver, tighten the two screws until snug.
Then, tighten each screw alternately until faucet is secure. Do
not overtighten!
Step 9 Inspect O-rings on lower faucet assembly. Lubricate with water-
soluble lubricant if needed.
Assemble the faucet
Step 10 Align the release button on the back of the upper faucet assembly
approximately 45° left off the back of the lower faucet assembly.
Step 11 Press the upper faucet assembly firmly on-to the lower faucet
assembly and twist clockwise until locked into place. Remove
battery cover on faucet handle, pull battery tab and replace
battery cover.
NOTICE
To Remove Upper Assembly press in the release button and
twist upper faucet assembly counter- clockwise.
Do not remove upper faucet assembly until all water has
been drained from the system and system has been fully
depressurized.
NOTE: This faucet is equipped with a filter change indicator. The indicator light will flash BLUE while the water is being
dispensed. After approximately six months or 2000 gallons of filtered water used the light will change to RED, indicat-
ing that filters should be changed. After filter change you must reset the monitor (Follow the Faucet Indicator Battery
Replacement procedure on page 13).
DANGER
This product contains a button cell battery. If swallowed, it could cause severe injury or death in
just 2 hours. Seek medical attention immediately.
INSERT
INTO BLUE
PORT ONLY
FRONT
LOWER
FAUCET
ASSEMBLY
UPPER
FAUCET
ASSEMBLY
BACK
TWIST UPPER
ASSEMBLY 45°
ONTO BASE
FAUCET
RELEASE
BUTTON
BATTERY
TAB
O-RINGS
FRONT
RUBBER
WASHER
LOCKING
TABS
Figure A
Figure B
Figure C