Owner Manual

Page 7
INSTALLATION
D
B
Line from
Angle Stop
Valve
Faucet
Connection
Faucet Line
Angle Stop
Valve
C
B
A
D
B
Line from
Angle Stop
Valve
Faucet
Connection
Faucet Line
Angle Stop
Valve
C
B
A
Adapt-a-Valve Installation
NOTICE
Do not use Teflon tape with the Adapt-A-Valve™.
For 1/2” Configuration
Parts List for Adapt-A-Valve
Item Description
A Brass Adapter with black washer
B Plastic Adapt-A-Valve & black collet
C White Rubber Washer
D Brass Adapter with no washer
For 3/8” Configuration
Step 12: Turn off the hot and cold water valves to the faucet by turning the angle stop valve completely off.
Step 13: Open sink faucet to relieve pressure from both the hot and cold water side.
Step 14: Choosing the configuration that fits your plumbing, attach the Adapt-A-Valve™ as illustrated in the
diagrams above for both the hot and cold valves.
NOTICE
Make sure that the black collet is installed in to the 1/4” opening on the Adapt-a-valve. Don’t
forget to install the white compression washer with the 3/8” configuration. The Brass Adapters
do not need to be tightened with a wrench, only finger tight.