Use & Care Guide

Specification:HeatWeave

Page1

PART 1 GENERAL
1.1 SECTION INCLUDES
A. Radiant floor heating systems for various floor constructions and control strategies,
using electric heating mats and cable assemblies.
1.2 RELATED SECTIONS
A. Section 03300 – Concrete
B. Section 06100 – Rough Carpentry
C. Section 07210 – Insulation
D. Section 15774 – Radiant-Heating Electric Cables
1.3 REFERENCES
A. General: Standards listed by reference, including revisions by issuing authority, form
a part of this specification section to the extent indicated. Standards listed are
identified by issuing authority, authority abbreviation, designation number, title or
other designation established by issuing authority. Standards subsequently
referenced herein are referred to by issuing authority abbreviation and standard
designation.
B. Canadian Standards Association (CSA):
1. CAN/CSA C22.2 No. 130 – Requirements for Electrical Resistance Heating
Cables and Heating Device Sets
2. CSA C02.2 No. 24 – Temperature-Indicating and –Regulating Equipment
3. CAN/CSA C22.2 No. 14 – Industrial Control Equipment
C. National Fore Protection Association (NFPA):
1. NFPA 70, National Electrical Code (NEC), especially Sec. 424 and 426
D. Tile Council of North America (TCNA):
1. Any applicable standards relating to the installation of tile or stone.
2. TCNA #RH115-0 – Latex – Portland Cement Mortar, Electric System
3. TCNA #RH116-07 – Cementitious Self-leveling Underlayment, Bonded Electric
System Thin-set
4. TCNA #RH130-07 – EGP (Exterior Glue Plywood) Latex – Portland Cement
Mortar Electric System
5. TCNA #RH135-07 – Backer Board Electric System Thin-set
E. Underwriters Laboratory (UL):
1. UL Standard 508A – Industrial Control Panels
2. UL Standard 515 – Electric Resistance Heat Tracing for Commercial and
Industrial Applications
3. UL Standard 758 – Appliance Wiring Materials
4. UL Standard 873 – Temperature-Indicating and Regulating Equipment