Spec Sheet

For Residential and Light Commercial Applications
ES-WQ-PWMB
Job Name
–––––––––––––––––––––––––––––––––––––––––––
Contractor
––––––––––––––––––––––––––––––––––––––––––––
Job Location
–––––––––––––––––––––––––––––––––––––––––
Approval
–––––––––––––––––––––––––––––––––––––––––––––
Engineer
–––––––––––––––––––––––––––––––––––––––––––––
Contractor’s P.O. No.
––––––––––––––––––––––––––––––––––
Approval
–––––––––––––––––––––––––––––––––––––––––––––
Representative
––––––––––––––––––––––––––––––––––––––––
Melt Blown Filter
Cartridges
Flow Rates: Up to 20 gpm (75 lpm) on
4
1
2" x 20" cartridges
The Watts series of Melt Blown Cartridges reduce sediment,
dirt, rust and particles. Food grade for use with beverages,
food, and potable water. A wide range of lengths and micron
ratings are available.
Features
• Low cost
Excellent chemical resistance
Food grade for food and beverages
No media migration
High dirt holding capacity
Wide range of lengths
Five different micron ratings
Applications
• Potable water
• Beverages
Pre-filtration for RO
• Fine chemicals
• Metal finishing
• Plating solutions
Watts product specifications in U.S. customary units and metric are approximate and are provided for reference only. For precise measurements,
please contact Watts Technical Service. Watts reserves the right to change or modify product design, construction, specifications, or materials with-
out prior notice and without incurring any obligation to make such changes and modifications on Watts products previously or subsequently sold.
0 2 4 8 10
1.0
.8
.6
.4
.2
0
1 Mic.
Flow (GPM)
Pressure Drop (psi)
5 Mic.
20 Mic.
50 Mic.
Pressure Drop -
For Cartridges 2
1
2" Dia. x 10" length
Specifications
Material Melt blown polypropylene
Maximum temperature 140˚F / 60˚C
Maximum pressure 40 PSID
Recommended change out 30 PSID
Maximum flow rate See Pressure Drop Chart
Cartridge packaging Shrink wrapped for purity
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or
after the system.
WARNING
!
The information contained herein is not intended to replace the
full product installation and safety information available or the
experience of a trained product installer. You are required to
thoroughly read all installation instructions and product safety
information before beginning the installation of this product.
NOTICE
This Component is Certified by WQA
against NSF/ANSI Standard 42 for
material requirements and to NSF/
ANSI 372 for Lead Free compliance.
Melt Blown Filter Cartridges

Summary of content (2 pages)