Instructions / Assembly

ManualsBrandsWatts ManualsKitchenOneFlow + Scale Prevention and Water Filtration System

Installation, Operation

and Maintenance Manual

OneFlow+ Salt-Free Scale Prevention

and Water Filtration

Model OFPSYS

IOM-WQ-OneFlow+

OFPSYS

WARNING

Please read carefully before proceeding with

installation. Your failure to follow any attached

instructions or operating parameters may lead to the

product’s failure.

Keep this Manual for future reference.

If you are unsure about installing your WATTS water filter, contact

a WATTS representative or consult a professional plumber.

Test the water periodically to verify that the system is performing

satisfactorily. Discard small parts remaining after the installation.

Failure to install the system correctly voids the warranty.

Handle all components of the system with care. Do not drop,

drag or turn components upside down.

Be sure the floor under the water filter system is clean, level

and strong enough to support the unit.

IMPORTANT

CAUTION

NOTICE

WARNING

Untreated private well water may contain contaminants

with levels outside of the operating guidelines. Do not use

with water that is microbiologically unsafe or of unknown

quality without adequate disinfection before or after the

system.

IOM-WQ-OneFlow+_nowqa.indd 1 10/20/2015 11:23:34 AM

Summary of content (4 pages)

PAGE 1
IOM-WQ-OneFlow+ Installation, Operation and Maintenance Manual OneFlow+ Salt-Free Scale Prevention and Water Filtration Model OFPSYS ! WARNING Please read carefully before proceeding with installation. Your failure to follow any attached instructions or operating parameters may lead to the product’s failure. Keep this Manual for future reference. ! WARNING Untreated private well water may contain contaminants with levels outside of the operating guidelines.
PAGE 2
Introduction Installation Instructions Thank you for your purchase of Watts OneFlow+ salt-free scale prevention and water filtration system. This Watts water treatment system has been designed and tested to provide you with high quality drinking water fand scale prevention for years to come. New systems come with the cartridges and outlet connector pre-installed. Installer should verify this during installation. NOTICE 1.
PAGE 3
Changing the Filter Cartridges NOTICE 1. Turn off water supply at either the isolation tap or mains tap. 2. Use the Multifunction Tool (Item 9) to release air from the system. This is done by taking the tool and unscrewing the Pressure Relief Valve (Item 3) refer Diagram F. 3. Use Multifunction Tool (Item 9) to unscrew OneFlow+ Head Assembly (Item 2)) anticlockwise and remove from the OneFlow+ Housing as shown in Diagram G. 4.
PAGE 4
WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information: www.watts.com/prop65 LIMITED WARRANTY: Certain Watts products come with a limited warranty from Watts Regulator Co. Other products may have no warranty or are covered by the original manufacturer’s warranty only. For specific product warranty information, please visit www.watts.com or the published literature that comes with your product.