Specifications

X, P, and K 11644A 1-3
General Information
Calibration Kit History
Equipment Required but Not Supplied
Cleaning supplies and various electrostatic discharge (ESD) protection devices are not
supplied with the calibration kit but are required to ensure successful operation of the kit.
Refer to
Table 7-4 on page 7-10 for their associated part numbers.
Calibration Kit History
This manual applies to any Agilent 11644A series (X, P, or K) waveguide calibration kits
whose serial number prefix is 3032A and above. If your calibration kit has a different
serial number prefix, refer to the next section for information on how this manual applies.
11644A Series Kits with Serial Prefix 3012A
These calibration kits did not have a calibration definitions disk to support the Agilent
8510C network analyzer. The part numbers provided in this manual are the recommended
replacement parts for these kits. The devices in these kits should meet the specifications
published in this manual.
Incoming Inspection
Verify that the case and its contents are not damaged. The foam-lined storage case
provides protection during shipping. If the case or any device appears damaged, or if the
shipment is incomplete, refer to
“Contacting Agilent” on page 6-4. Agilent will arrange for
repair or replacement of incomplete or damaged shipments without waiting for a
settlement from the transportation company. Refer to
“Returning a Kit or Device to
Agilent” on page 6-3.