User's Manual

Version 3.03 SPEEDLAN 9000 Series Installation and Operation User Guide

IP Recovery (Appendix B)-6

Note: The minimum password length is 8 characters. The maximum password length is

16 characters (including the underscore character or spacebar).

6 Click OK on the Set Temporary IP Address dialog box.

7 Next, you will receive a message confirming that the temporary IP address has

been set, as shown below. Click OK to close this message box.

Message confirmation

8 Finally, click OK or click Cancel to re-enter your settings.

Temporary IP address complete

9 Now you can connect to the router via the SPEEDLAN 9000 HTML

Configurator to make any changes/configurations to the router.

Transmit Power Test

You are encouraged to use the transmit power test during installation if you have a

spectrum analyzer or power meter to measure the output for the antenna alignment. It

should not be used on a running network because it will disrupt the network for the

duration of the test. To perform a power transmit test, follow these steps:

Note: Clicking the Configure button

will start the SPEEDLAN 9000

Configurator using the new

temporary IP address. The Config.

will automatically enter the default

password (e.g., "wave_full").

displays

netmask