User's Manual

SPEEDLAN 9000 Series Installation and Operation User Guide Version 3.03
Using the Configurator to Set Up Special Parameters for Point-to-Point Routers 6-15
Now the remotes are automatically rebooted after a successful upgrade. The
local or connected router is not rebooted until you click the Reboot Updated
Nodes button at the end of the upgrade.
Updating the Software on a Local Router and Remote Router:
Primary Mode Only
To update the software on a location router and on a remote point-to-point primary
router, choose it under the Software Update submenu.
Figure 6-11: Updating the software for a point-to-point primary router (in Primary
mode only)
This operation is a two-step process:
1 Select the point-to-point routers where you want to update the software. (The
IP addresses that are selectable are active. If only a MAC address is listed, or a
bunch of zeros, then these represent inactive devices.
2 Upload the Software Update file. Locate the latest software file (by clicking
Browse) and click Upload Software Update File to Selected Nodes.
3 Install the Software Update. All other common configuration information
can be found in General Functions of the Configurator, page 3-1.