User's Manual

SPEEDLAN 9000 Series Installation and Operation User Guide Version 3.03
Using SPEEDView 8-23
• Show Hostname: Click to show the hostname of the wireless node (displays
on node on Main tab).
• Show Wired IP: Click to show the wired IP address and netmask. (The Star
diagram network, as shown in “Star Network” on page 6, shows an example
of this button being enabled. The Mesh diagram, as shown in “Mesh Network”
on page 7, shows an example of this button NOT being enabled.)
• Missing Links Visible: Click to display broken links. The broken (or
disconnected) link will appear as a red, dashed line. This link appears when
there is no signal strength between nodes. If this item is not selected, the link
will be absent between the broken links.
• Signal Link Indicators: Selecting this item will produce graphical link
indications to show which link a Signal label is attached to. This is useful for a
large number of nodes. In order to display the signal, you must have clicked
Signal (on the Main tab).
• Show Noise: Click to display the noise for the wireless node (displays to the
right of the Signal on the Main tab). In order to display the noise, you must
have clicked Signal (on the Main tab).
• Show IP Address: Click to display the wired IP address (displays near node on
Main tab).
• Show Wireless IP: Click to display the wireless IP address (displays near node
on Main tab).
• Show Firmware: Click to display firmware version (displays near node on
Main tab).
• Anim Timer (Animation Timer): Select this drop-down list to change the
animation speed during a trace route test. The speed is measured in
milliseconds.
• Signal Font: To change the font size of the signal, click this drop-down list
and select one of the following: default, tiny, small, medium or large.
• IP Label Octets: To change how many octets appear for the label (IP address
or IP label) on the Main tab, click this drop-down list. You can select up to 4
octets. (Note that selecting “4” will display the full IP address.)
• Node Label Font: This is the font used to display the IP Label. To change the
size, click this drop-down list and select one of the following: default, tiny,
small, medium or large.
• Node Icon: This displays how the SPEEDLAN 9000 node will appear on the
Main tab. You can select one of the following: Smiley Face, Node,
SPEEDView icon (small and large) or a Computer icon.