User Manual

SPEEDLAN 9000 Series Installation and Operation User Guide Version 3.03
Appendix F (SPEEDSignal)-5
Installing the Compaq WL100 Wireless LAN PC Driver and ActiveSync
To install the wireless driver and ActiveSync, follow the directions below:
1 Plug the AC Adapter into an outlet. Next, connect the AC adapter to the
Pocket PC PDA’s cradle. The serial or USB connector (not both) on the cradle
should be connected to the appropriate port on the front or back of your
desktop PC. On the desktop PC, start Active Sync. Insert the Pocket PC PDA
into the cradle. Refer to the installation diagram below to see how the
components should be connected.
Note: If you have not previously installed a USB device, you will be prompted
to install the USB device driver.
2 Using ActiveSync, establish a connection between the Pocket PC PDA and the
desktop PC. (The Pocket PC PDA should now be in the cradle.)
Note: If you do not have ActiveSync, download it from this website: “http://
www.microsoft.com/mobile/pocketpc/downloads/”. Under Microsoft
Downloads, locate ActiveSync and download it. Note: It may take a few
minutes to download ActiveSync.
Follow the ActiveSync install prompts and instructions. ActiveSync will detect
the connection for the Pocket PC PDA. Continue to follow the onscreen
installation prompts to establish a connection between the Pocket PC PDA and
desktop PC. When you are prompted do establish a partnership, click No or
click Guest. For more information, refer to the Pocket PC PDA’s manual.
3 If you WLAN driver does not support pseudo adhoc mode, you will need to
uninstall these drivers.
Plug AC Adapter
Cradle (Insert Pocket PC PDA into cradle)
USB to Desktop PC
Serial to Desktop PC
into wall outlet