User Manual

SPEEDLAN 9000 Series Installation and Operation User Guide Version 3.03
Using the Configurator to Set Up Special Parameters for Point-to-Point Routers 6-5
primary node is running firmware version 2.21 or higher, it will automatically optimize
the point-to-point link.
Authentication section
•
Using MAC Address: Select this check box if you want to use the factory
default address (MAC layer self learning router mode) for the point-to-point
router. Click Apply to activate selection.
• Using Pass Phrase: Select this check box if you want to use the pass phrase.
The pass phrase for the point-to-point router must match the pass phrase for
the router it is communicating with. Click Apply to activate selection.
If you clicked the Secondary Node Settings Button...
You will also be able to enable encryption for your point-to-point secondary router.
• If you want the router to be connected to the network, click the Enable Node
check box. If you want to disable the router from the network, make sure this
check box is not selected. Encryption is locked if the lock image is displayed,
and encryption is unlocked if the unlocked image is displayed under the
"Encrypt" column.
• Click Modify to change an existing pass phrase. Click Create if the pass
phrase has not been set.
Note: You can configure a point-to-point (primary or secondary) router on this page if
you delete the existing one by clicking Delete.
• Click Apply Changes after making changes.