User Manual

Version 3.03 SPEEDLAN 9000 Series Installation and Operation User Guide
6-8 Using the Configurator to Set Up Special Parameters for Point-to-Point Routers
• If you click the Tx Retries button, you will be able to set the Transmit Retry Limit
and Signaling Rate Fallback. For more information, see Max Tx Retries and
Signaling Rate Fallback, page 6-10.
• If you click the Max Throughput button, you will be able to set the Max
Transmit Data Rate in Kb/s. For more information, see Max Throughput
(Regulating Bandwidth), page 6-12.
Channel and Rates
Figure 6-6: Channel and Rates (Point primary and secondary)
• Primary Firmware: This is the current primary firmware version in use by the
wireless card.
• Station Firmware: This is the current station firmware version in use by the
wireless card.
• Channel: This is the specific band of frequencies (from 1 to 11) to determine
the data path between routers. All SPEEDLAN 9000 routers expected to
communicate in a network must have the same channel (frequency). Select
one of the following channels (all are represented in GHz) from the Channel
drop-down list:
version: v