User Manual

Version 3.03 SPEEDLAN 9000 Series Installation and Operation User Guide
6-14 Using the Configurator to Set Up Special Parameters for Point-to-Point Routers
After you have unzipped the file, make sure you extract the update file (.wwn) file to
your desktop. Then, follow the directions below.
To update the software on the local router or on the remote point-to-point routers,
choose Software Update from the Admin menu. The Software Update page will
appear.
Updating the Local Router
If you only need to update the software on a local point-to-point primary or secondary
router, choose Local (under the Software Update submenu).
Figure 6-10: Updating the software for point-to-point primary or secondary local
router (in Primary or Secondary mode)
This operation is a two-step process:
1 Upload the Software Update file. Locate the latest software file (by clicking
Browse) and click Upload Software Update File.
2 Install the Software Update. Note: When you updated your network in the
past, the remotes would not have been rebooted until the final step. This step
happened after you clicked the Reboot Updated Nodes button.