User Manual

Version 3.03 SPEEDLAN 9000 Series Installation and Operation User Guide
7-12 Using the Configurator to Set Up Special Parameters for Mesh Routers
• 11 Mb/s: 81
• 5.5 Mb/s: 88
• 2 Mb/s: 89, and
• 1 Mb/s: 92
The current Rx thresholds for your wireless mesh router(s) are listed in the Current Rx
Thresholds section. Their signaling rates are also listed, as described above.
If you click Default, it will load the current default setting for the Configurator. Click
Apply when finished.
Blocked Links
Figure 7-8: Blocking Mesh Routers
This feature allows you to block all traffic from a specific hardware address. This is most
often used when a marginal signal exists between two nodes in a mesh network, such
that the network functions more reliably when no direct communication occurs between
the nodes. To completely block a link you must perform the same action on the remote
node.
Select the checkbox
under Blocked to block
a mesh router. Leave it
unselected when you
want leave the mesh
router unblocked.
(Mesh)