User Manual

Version 3.03 SPEEDLAN 9000 Series Installation and Operation User Guide
4-4 Using the Configurator to Set Up Special Parameters for a Base Station
• Click System Wide Settings (left circle in Figure 4-2 on page 4-3) to set the
timing parameters for the CPE routers on the star network. This will bring up a
page where you can control how a base station treats CPE routers during time
periods when they have no network traffic to send and set the pass phrase for
all CPE routers. The following sections will be on this page:
• See Authentication Section, page 4-4
• See Star Timing Parameters Section, page 4-7
• Click Per CPE Settings (right circle in Figure 4-2 on page 4-3) to bring up a
page so you can turn on encryption. For more information, see If you clicked
Per CPE Settings Button..., page 4-8.
If you clicked the "System Wide Settings" button...
Figure 4-3: System Wide Settings page
Authentication Section
•
Using MAC Address: Select this check box if you want to authenticate using
the MAC address. Then, click Apply.
• Using Pass Phrase: Select this check box if you want to authenticate using the
pass phrase. Then, click Apply.
Click Defaults to load
the proper default
settings for the Config.