User Manual

SPEEDLAN 9000 Series Installation and Operation User Guide Version 3.03
Using the Configurator to Set Up Special Parameters for a Base Station 4-9
Note: You can configure a base station router on this page if you delete the existing
one by clicking Delete.
4 Click Create if the CPE was never given a pass phrase (and it is blank). The
following dialog box will appear.
Figure 4-5: Set Pass Phrase for Unit box
5 Enter the appropriate information and click Set Pass Phrase when you are
done. (Pass Phrases have a minimum of 8 characters and a maximum of 32
characters.) Then, exit this dialog box go back.
6 Click Apply Changes to update the system.
Other elements on the Per CPE Settings page:
• All (at bottom of page): Click to select all routers under the appropriate
category (Enable, Encrypt, MAC or Pass).
• None (at bottom of page): Click to clear all routers under the appropriate
category (Enable, Encrypt, MAC or Pass).
• Delete: Click to remove the hardware address.
• Apply: Click after making changes.