User Manual

Version 3.03 SPEEDLAN 9000 Series Installation and Operation User Guide
2-8 SPEEDLAN 9101, 9102, 9103 & 9104 Hardware
The following items are included with the installation kit, which can be purchased
separately:
• Hardware ties
• Specialized CAT5 cable
Customer Sourced / Other
• Combination wrench or socket wrench (7/16") to tighten the nuts on the V-
bolts (customer sourced only)
• Other tool accessories that can be purchased separately from Wave Wireless
are: cable, connectors, crimpers, spectrum analyzer, shrink wrap, APC
10BaseT putty, aluminum 2" pole, extendable mast, ballast mount, peak roof
mount, extra v-bolts, nuts, grounding rod clamps, wall mounts
Installation Steps for the SPEEDLAN 9101/9104
To install your SPEEDLAN 9101, follow the steps below:
Step 1: Mounting the SPEEDLAN 9101/9104
This router will have an omni attached via an RF cable assembly. No additional steps
are needed for this step. Go to Step 2.
Step 2: Mounting the SPEEDLAN 9101/9104 on the Pole
• Pole Mount: Attach the router to the mounting pole using the two V-bolted
clamps, one on top of the router and the other on the bottom of the router.
Make sure you tighten the nuts for the clamps on the back of the pole mount.
Step 3: Running the Cabling
1 Run outdoor CAT5 cable (from bottom of router) down to junction box located
inside the building.
2 Secure grounding wire by running this wire to a suitable "earth" ground and
fasten it securely in place. See the installation diagram following
these directions.
3 Install the ground plug into the junction box. Install the Ethernet to the radio
cable. Install the Ethernet to the router. Install the DC connector to the junction
box. Plug the external power supply into the wall outlet.
(The VAC power outlet’s input voltage of this universal adapter can vary from
100 to 250 VAC.) Connect the DC output of the adapter to DC jack on the
indoor junction box.