User Manual
SPEEDLAN 9000 Series Installation and Operation User Guide Version 3.03
General Functions of the Configurator 3-35
The following RIP Settings parameters are described below:
• Off: Select this option to disable RIP.
• On: Select this option to enable RIP.
• RIP 1 and RIP 2: Select to enable RIP 1 and RIP 2.
• Receive: This is from the incoming location.
• Send: This is from the outgoing location.
Receive and Send options:
• Global: Click this option to receive/send RIP 1, RIP 2 or RIP 1 & 2 throughout
the entire network.
• RIP 1: Click this option to receive/send RIP1 from/to the interface.
• RIP 2: Click this option to receive/send RIP2 from/to the interface.
• RIP 1 and 2: Click this option to receive/send RIP 1 & 2 from/to the interface.
Authentication:
• None: Select this option when no authentication is needed.
• Password: Select this option when authentication is needed and then enter the
password to the right of this option. (Authentication password has a minimum
of 8 characters and a maximum of 32 characters.)
Click Apply when you are finished making changes.
Network Route Filters:
• Distribute any routes except for the following: Select this option to
distribute all the network route routes except those which are selected in the
Filters box.
• Do not distribute any routes except for the following: Select this option to
only distribute the selected network route filters in the Filters box.
• Filters box: Select those filters needed for option 1 or 2 as explained above.
• Add: Click this button to add a network route filter to the Filters box.
• Delete: Click this button to remove a network filter from the Filters box.
• Add Private: Select the private address from this drop-down list if you want to
include a private address in the Network Route Filters list.