User's Manual

SPEEDLAN Installation and Operation User Guide
Analyzing Wireless Equipment 13-3
Analysis Polling Interval
Use the feature to set the rate at which the SPEEDLAN Configurator polls the brouter during analysis.
Note that you must scan the brouter before setting the interval rate.
To set the rate of the interval, do the following:
1 From the Analyze menu, choose Analysis Interval. The Analysis Polling Interval dialog box
appears.
2 Use your mouse and move the interval to the rate of your specification. Then, click OK.
Wireless Link Test
Run the wireless link test to verify that your equipment is communicating properly at the RF level. This
test can be performed when you are performing a bench test for the brouter or from the actual link.
This process will help you during your performance evaluation. If you already scanned the brouter
(or bridge pair), skip to Step 5.
To initialize a link test, do the following:
1 From the File menu, choose Open Remote Config. Then, click Scan.