User Manual

. . . . .
HARDWARE INSTALLATION
Wireless Router Installation
Hardware Installation Guide 3-3
The indoor antenna connects to the rear of the AirPro Gold unit through
the N-type connector labeled ANT on the back of the radio. See
Figure 3-2. The outdoor antenna is connected through coaxial cable.
Figure 3-2 ANT Connector
To connect an indoor antenna to the AirPro Gold unit:
1 Plug the antenna connector firmly into the N-type antenna connector on the
back of the unit.
2 Hand-tighten the connector shell onto the jack connector collar.
3 Verify that the connector is fixed firmly in place.
To connect an outdoor antenna to the AirPro Gold unit:
1 Plug the coaxial antenna cable into the N-type antenna connector on the back of
the unit, making sure there are no sharp bends in the cable.
• Install the coaxial cable between the radio and antenna location, making sure
there are no sharp bends in the cable.
2 Hand-tighten the connector shell onto the jack connector collar.
3 Verify that the cable is fixed firmly in place.
If the antenna coaxial cable is too stiff to bend easily, add a flexible pigtail
coaxial cable with a coax barrel (available from P-Com).
POWER CONNECTION
To connect power to the AirPro Gold unit:
1 Plug the AC power cord into the 3-pin connector on the back of the unit. See
Figure 3-6 on page 3-8
2 Plug the AC power cord into a grounded electrical outlet.
To avoid electrical shock or power loss, make sure that the power cord is
securely connected to the unit. Do not use a 3-pole to 2-pole adapter with the
plug. Verify that the outlet you use is properly installed, grounded, and
complies with the local electrical code.
3 Turn the AC power switch to ON. See Figure 3-6 on page 3-8.
APG2_016
MADE IN USA
MAC ADDRESS:
ANT
Antenna Connector
NOTE
✐