User's Manual
Table Of Contents
- Features and Benefits
- SPEEDLAN 9200 Mesh Protocol -- How It Works in Mesh Cells
- Document Changes/Corrections
- Contacting Technical Support
- Rooftop and Tower Installations Warning
- Regulatory Information
- Declaration of Conformity for RF Exposure
- General Safety Requirements for Installation of SPEEDLAN 9200 Models
- Hardware Overview
- Drawings of Outdoor, Remote-Mounted Components
- The SPEEDLAN 9202/SPEEDLAN 9203/SPEEDLAN 9205 with External Antenna
- Manual Initial Configuration of the SPEEDLAN 9200
- Overview of the SPEEDLAN 9200 Configurator General Main Menu
- Logging on the SPEEDLAN 9200 Configurator
- Helpful Information to Know...
- The Configuration Menu
- Network Menu
- System Menu
- Routing Menu
- Configuring the Radio Parameters
- DHCP Server Menu
- Setting Up DHCP and DHCP Relay
- Forwarding Menu
- Three Features of NAT
- Firewall
- IP Sessions
- Diagnostics Menu (Troubleshooting the Network)
- Admin Menu
- Network Menu
- Wireless menu
- Admin Menu
- Basics of IP Addressing
- Basics of Routing
- Glossary for Standard Data Communications
- Glossary for Standard Data Communications
- Appendices (A-F)
- Changing the Router's Topology Mode
- SPEEDLAN 9200 Configurator Passwords
- Manufacturer Information
- Radio Approvals
- SPEEDLAN 9200 Technical Specifications
- List of Acronyms
- Channels for IEEE 5GHz OFDM (UNII upper band)
- 2.4GHz DSSS Channels 2.4GHz OFDM Channels
- Software License Agreement
Part # 34357-MNL Rev.03 SPEEDLAN 9200 User Guide
3-76
Support
This page displays some support function features for Technical Support, Access to
SPEEDSignal (for Pocket PC) and Reset to Factory Default. You can access these
features by choosing Support from the Admin menu. The following page will appear:
Figure 3-53: Support page
The elements on this page are explained below:
Access By Manufacturer's Tech Support
This is where you can enable the manufacturer to access the router for advanced
troubleshooting (by choosing the Enabled option). The factory default is disabled and
should remain disabled unless requested by a manufacturer's technical support
representative (by choosing the Disabled option). Click Apply when finished.
Access to Wireless SPEEDSignal
This feature is used to enable or disable Pocket PC PDAs to communicate with
SPEEDSignal.
• Click the Enabled option to enable communication with SPEEDSignal.
• Click the Disabled option to disable communication with SPEEDSignal. Click
Apply when finished.
Reset to Factory Default
If you need to reset the entire configuration of the SPEEDLAN 9200 to factory default
settings, click Reset All Configuration to the Factory Default.