User's Manual
Table Of Contents
- Features and Benefits
- SPEEDLAN 9200 Mesh Protocol -- How It Works in Mesh Cells
- Document Changes/Corrections
- Contacting Technical Support
- Rooftop and Tower Installations Warning
- Regulatory Information
- Declaration of Conformity for RF Exposure
- General Safety Requirements for Installation of SPEEDLAN 9200 Models
- Hardware Overview
- Drawings of Outdoor, Remote-Mounted Components
- The SPEEDLAN 9202/SPEEDLAN 9203/SPEEDLAN 9205 with External Antenna
- Manual Initial Configuration of the SPEEDLAN 9200
- Overview of the SPEEDLAN 9200 Configurator General Main Menu
- Logging on the SPEEDLAN 9200 Configurator
- Helpful Information to Know...
- The Configuration Menu
- Network Menu
- System Menu
- Routing Menu
- Configuring the Radio Parameters
- DHCP Server Menu
- Setting Up DHCP and DHCP Relay
- Forwarding Menu
- Three Features of NAT
- Firewall
- IP Sessions
- Diagnostics Menu (Troubleshooting the Network)
- Admin Menu
- Network Menu
- Wireless menu
- Admin Menu
- Basics of IP Addressing
- Basics of Routing
- Glossary for Standard Data Communications
- Glossary for Standard Data Communications
- Appendices (A-F)
- Changing the Router's Topology Mode
- SPEEDLAN 9200 Configurator Passwords
- Manufacturer Information
- Radio Approvals
- SPEEDLAN 9200 Technical Specifications
- List of Acronyms
- Channels for IEEE 5GHz OFDM (UNII upper band)
- 2.4GHz DSSS Channels 2.4GHz OFDM Channels
- Software License Agreement
Part # 34357-MNL Rev.03 SPEEDLAN 9200 User Guide
4-6
To enable or disable the SPEEDMesh client, do the following:
1 Choose Mobile Client from the Network menu. The Mobile Client page will
appear:
Figure 4-4: Enabling/disabling the SPEEDMesh client
2 To enable the SPEEDMesh client, select the Enable Mobile Client check box.
3 Select the nodes you want to enable for SPEEDMesh-enabled client mode
node via one node, all nodes (via Select All) or unselect all nodes (via Clear
All).
4 Click Apply to Selected Nodes to active the SPEEDMesh client.
Note: If you forgot to enable WEP security, see B. Enabling WEP Security Between a
SPEEDMesh-Enabled Client and SPEEDLAN 9200, page 4-4.
Wireless menu
Choose one of the options from the Wireless menu:
• If you choose Configuration, you will be able to set the following radio
parameters: SSID, wireless mode, channel, signaling rate, turbo mode, Tx
power and preamble. For more information, see Configuration, page 3-38 for
more details.
• If you choose Tx Retries, you will be able to set the Transmit Retry Limit and
Signaling Rate Fallback. For more information, see Max Tx Retries and Signal-
ing Rate Fallback, page 3-41.