User's Manual
Table Of Contents
- Features and Benefits
- SPEEDLAN 9200 Mesh Protocol -- How It Works in Mesh Cells
- Document Changes/Corrections
- Contacting Technical Support
- Rooftop and Tower Installations Warning
- Regulatory Information
- Declaration of Conformity for RF Exposure
- General Safety Requirements for Installation of SPEEDLAN 9200 Models
- Hardware Overview
- Drawings of Outdoor, Remote-Mounted Components
- The SPEEDLAN 9202/SPEEDLAN 9203/SPEEDLAN 9205 with External Antenna
- Manual Initial Configuration of the SPEEDLAN 9200
- Overview of the SPEEDLAN 9200 Configurator General Main Menu
- Logging on the SPEEDLAN 9200 Configurator
- Helpful Information to Know...
- The Configuration Menu
- Network Menu
- System Menu
- Routing Menu
- Configuring the Radio Parameters
- DHCP Server Menu
- Setting Up DHCP and DHCP Relay
- Forwarding Menu
- Three Features of NAT
- Firewall
- IP Sessions
- Diagnostics Menu (Troubleshooting the Network)
- Admin Menu
- Network Menu
- Wireless menu
- Admin Menu
- Basics of IP Addressing
- Basics of Routing
- Glossary for Standard Data Communications
- Glossary for Standard Data Communications
- Appendices (A-F)
- Changing the Router's Topology Mode
- SPEEDLAN 9200 Configurator Passwords
- Manufacturer Information
- Radio Approvals
- SPEEDLAN 9200 Technical Specifications
- List of Acronyms
- Channels for IEEE 5GHz OFDM (UNII upper band)
- 2.4GHz DSSS Channels 2.4GHz OFDM Channels
- Software License Agreement
SPEEDLAN 9200 User Guide Part # 34357-MNL Rev.03
4-11
This operation is a two-step process:
1 Upload the Software Update file. Locate the latest software file (by clicking
Browse) and click Upload Software Update File.
2 Install the Software Update.
Note: All units are automatically rebooted after a successful upgrade.
Updating the Software on a Local Router and Remote Router
To update the software on a location router and on a remote router, choose it under
the Software Update submenu (e.g., MeshNet).
Figure 4-10: Updating the software for a local mesh and remote router
This operation is a two-step process:
1 Select the remotes where you want to update the software. (The IP addresses
that are selectable are active. If only a MAC address is listed, or a bunch of
zeros, then these represent inactive devices.
2 Upload the Software Update file. Locate the latest software file (by clicking
Browse) and click Upload Software Update File to Selected Nodes.
3 Install the Software Update.