User's Manual

SPEEDLAN 9200 User Guide Part # 34357-MNL Rev.03
2-9
• Hardware ties
• Specialized CAT5 cable
Customer Sourced / Other
• Combination wrench or socket wrench (7/16") to tighten the nuts on the V-
bolts (customer sourced only)
• Other tool accessories that can be purchased separately from P-Com are:
cable, connectors, crimpers, spectrum analyzer, shrink wrap, putty, aluminum
2" pole, extendable mast, ballast mount, peak roof mount, extra v-bolts, nuts,
grounding rod clamps, wall mounts
Installation Steps for the SPEEDLAN 9201/SPEEDLAN 9204
To install your SPEEDLAN 9201/SPEEDLAN 9204, follow the steps below:
Step 1: Mounting the SPEEDLAN 9201/SPEEDLAN 9204
This router will have an omni directly attached. No additional steps are needed for this
step. Go to Step 2.
Step 2: Mounting the SPEEDLAN 9201/SPEEDLAN 9204 on the Pole
• Pole Mount: Attach the router to the mounting pole using the two V-bolted
clamps and aluminum bracket, one on top of the router and the other on the
bottom of the router. Make sure you tighten the nuts for the clamps securely to
prevent shifting of the router after antenna alignment.
Step 3: Running the Cabling
1 Run outdoor CAT5 cable (from bottom of router) down to junction box located
inside the building.
2 Secure grounding wire by running this wire to a suitable "earth" ground and
fasten it securely in place. See the installation diagram following
these directions.
3 Install proper indoor ground plug into the junction box. Connect the outdoor
CAT5 Ethernet to the "radio" jack. Connect the LAN Ethernet cable to the "LAN"
jack of the junction box. Install the power supply DC connector to the junction
box. Plug the external power supply into the wall outlet.
(The VAC power outlet’s input voltage of this universal adapter can vary from
100 to 250 VAC.) Connect the DC output of the adapter to DC jack on the
indoor junction box.