User's Manual
Table Of Contents
- Features and Benefits
- SPEEDLAN 9200 Mesh Protocol -- How It Works in Mesh Cells
- Document Changes/Corrections
- Contacting Technical Support
- Rooftop and Tower Installations Warning
- Regulatory Information
- Declaration of Conformity for RF Exposure
- General Safety Requirements for Installation of SPEEDLAN 9200 Models
- Hardware Overview
- Drawings of Outdoor, Remote-Mounted Components
- The SPEEDLAN 9202/SPEEDLAN 9203/SPEEDLAN 9205 with External Antenna
- Manual Initial Configuration of the SPEEDLAN 9200
- Overview of the SPEEDLAN 9200 Configurator General Main Menu
- Logging on the SPEEDLAN 9200 Configurator
- Helpful Information to Know...
- The Configuration Menu
- Network Menu
- System Menu
- Routing Menu
- Configuring the Radio Parameters
- DHCP Server Menu
- Setting Up DHCP and DHCP Relay
- Forwarding Menu
- Three Features of NAT
- Firewall
- IP Sessions
- Diagnostics Menu (Troubleshooting the Network)
- Admin Menu
- Network Menu
- Wireless menu
- Admin Menu
- Basics of IP Addressing
- Basics of Routing
- Glossary for Standard Data Communications
- Glossary for Standard Data Communications
- Appendices (A-F)
- Changing the Router's Topology Mode
- SPEEDLAN 9200 Configurator Passwords
- Manufacturer Information
- Radio Approvals
- SPEEDLAN 9200 Technical Specifications
- List of Acronyms
- Channels for IEEE 5GHz OFDM (UNII upper band)
- 2.4GHz DSSS Channels 2.4GHz OFDM Channels
- Software License Agreement
SPEEDLAN 9200 User Guide Part # 34357-MNL Rev.03
3-19
If You Need a Temporary IP Address
• See the IP Recover chapter in the SPEEDManage User Guide.
OR
• If after learning the IP address of the Ethernet interface, you cannot log on to
the router using the HTML Configurator (SPEEDLAN 9200 Configurator), then
you will be able set a temporary Ethernet IP address so that a connection can
made.
The Configuration Menu
Network Menu
• Choose Interfaces to select the router you need.
• Choose IP Addresses from the Network menu to assign an IP address
(manually or dynamically via DHCP).
• Choose Virtual Addresses from the IP Addresses submenu (under the
Network menu) to create a public IP address that can be mapped to a private
IP address.
Network Interfaces
Choose the type of router as shown in Figure 3-13 on page 3-16. Then, click Apply.
IP Address Configuration
This is where you would assign IP Addresses either Manually (static) or via DHCP
(dynamic). For DHCP, you may also enter the hostname of the client.
To activate this page, choose IP Addresses and then the name of the interface (i.e.,
Ethernet, Star Net, Mesh Net) from the Network menu. The following page will
appear.