User's Manual

Part # 34357-MNL Rev.03 SPEEDLAN 9200 User Guide
3-24
NAT rule. Version 3.0 and higher requires explicit creation of a virtual address prior to
referencing it. Virtual addresses can be used to access the SPEEDLAN 9200 router for
configuration, or in NAT functions like Address Sharing, Internal Servers, and 1:1 NAT.
Virtual addresses are particularly useful when using 1:1 NAT, where you need more
than one public IP address. The virtual addresses do not need to belong to a network
assigned to one of the SPEEDLAN 9200's interfaces.
The existence of these addresses will be advertised with RIP, providing that the RIP filters
allow it. The Virtual Address page will appear when you choose the Virtual Addresses
feature.
The elements on this page are explained below:
• IP Address: In this text box, enter the virtual address you want to add. Click
Add to add the new virtual address. (In the next figure, the user entered
"13.13.13.16" in the IP Address text box. Next, the user will click Add.)
Notes: You cannot apply an IP address from the Ethernet port’s subnet.
All virtual addresses have a netmask of /32 (255.255.255.255).
Existing Virtual Addresses
This list contains all defined virtual addresses.
• To remove a virtual address, select it and click Delete Selected. (In the next
figure, if the user wants to remove virtual address "13.13.13.14". Then, the
user would select the check box next to it and click Delete Selected.)
• To select all addresses, click All. To clear all selections, click None.
If an entry has "(In Use)" instead of a check box (as shown in the next figure to the right
of virtual address "13.13.13.13"), this means the virtual address is "in use" and cannot
be removed.
Figure 3-17: Virtual address