User's Manual
Table Of Contents
- Features and Benefits
- SPEEDLAN 9200 Mesh Protocol -- How It Works in Mesh Cells
- Document Changes/Corrections
- Contacting Technical Support
- Rooftop and Tower Installations Warning
- Regulatory Information
- Declaration of Conformity for RF Exposure
- General Safety Requirements for Installation of SPEEDLAN 9200 Models
- Hardware Overview
- Drawings of Outdoor, Remote-Mounted Components
- The SPEEDLAN 9202/SPEEDLAN 9203/SPEEDLAN 9205 with External Antenna
- Manual Initial Configuration of the SPEEDLAN 9200
- Overview of the SPEEDLAN 9200 Configurator General Main Menu
- Logging on the SPEEDLAN 9200 Configurator
- Helpful Information to Know...
- The Configuration Menu
- Network Menu
- System Menu
- Routing Menu
- Configuring the Radio Parameters
- DHCP Server Menu
- Setting Up DHCP and DHCP Relay
- Forwarding Menu
- Three Features of NAT
- Firewall
- IP Sessions
- Diagnostics Menu (Troubleshooting the Network)
- Admin Menu
- Network Menu
- Wireless menu
- Admin Menu
- Basics of IP Addressing
- Basics of Routing
- Glossary for Standard Data Communications
- Glossary for Standard Data Communications
- Appendices (A-F)
- Changing the Router's Topology Mode
- SPEEDLAN 9200 Configurator Passwords
- Manufacturer Information
- Radio Approvals
- SPEEDLAN 9200 Technical Specifications
- List of Acronyms
- Channels for IEEE 5GHz OFDM (UNII upper band)
- 2.4GHz DSSS Channels 2.4GHz OFDM Channels
- Software License Agreement
SPEEDLAN 9200 User Guide Part # 34357-MNL Rev.03
3-25
Note: If you want to distribute virtual routes, make sure the Static Routes check box is
selected on the RIP Global Settings page under the Routing / RIP2 Setup / Global
Settings menu.
System Menu
• Choose Config Summary to view a summarized configuration of the units.
• SNMP: The SPEEDLAN 9200 contains a Simple Network Management
Protocol (SNMP) Agent that provides a remote Network Management System
(NMS) with read-only ("get") access to certain configuration and status
parameters. For more information, choose SNMP.
• Choose Version to view the current version information.
• Choose Host Name to enter a name of the host.
• Choose Password to modify the password entries.
• Choose Reboot to reboot the system.
Configuration Summary
To view a summarized list of the configuration on the units, choose Config Summary
from the System menu. (You can also select the Config Summary link in the upper-
right hand corner of each page.) This is very useful tool if you want to capture a screen
shot of the summary and email it to technical support. The Configuration Summary for
the Host page will appear displaying a summary which includes the following
information:
• System Version: Displays the firmware version and uptime for the unit.
• SNMP: Displays the read-only SNMP statistics, which are described in SNMP,
page 3-26.
• Network Interfaces: Displays the interfaces on the network.
• Route Table: Displays the routing information between destinations.
• Wireless Configuration: Displays the channel, signaling rates, Max Tx
Retries, Signaling Rate Fallback, Max Throughput, Rx Threshold and
Link Expiration.
• Blocked Wireless Links: Displays blocked links. For more information, see
Receive (Rx) Threshold Parameter, page 4-7.