User's Manual

Part # 34357-MNL Rev.03 SPEEDLAN 9200 User Guide
3-26
• Wireless Security Settings: See Enabling Network Security, page 4-3.
• RIP Configuration: The routing table displays routing information between
destinations.
• Routing Configuration: Indicates if RIP is on or off, lists global settings and
send and receive information, authentication and distribute information.
• DHCP Server Configuration: Indicates if DHCP Server Configuration is on
or off.
• DHCP Relay Configuration: Indicates if DHCP Relay Configuration is on or
off.
• Virtual Addresses: Displays virtual addresses.
• NAT: Lists the implementation(s) of NAT: address sharing, internal servers and
1:1 NAT.
• Firewall: Displays if the firewall is enabled or disabled.
• ARP Table: Displays Address Resolution Protocol statistics.
• Statistics: Displays statistics about the wireless inbound and outbound traffic.
Note: Select the appropriate feature (noted via blue-underlined hyperlink) to jump to
the proper feature page. For example, if you click the Firewall link on the
Configuration Summary page, it will bring up the Firewall page where you can modify
further information.
There is a short-cut link to the Configuration Summary by clicking the Config
Summary Link as circled in the figure below.
Figure 3-18: Config Summary Link
SNMP
The SPEEDLAN 9200 contains a Simple Network Management Protocol (SNMP) Agent
that provides a remote Network Management System (NMS) with read-only ("get")
access to certain configuration and status parameters. Those parameters are
Management Information Base (MIB) objects. The currently supported MIBs are
identified in table the MIBs.