User's Manual
Table Of Contents
- Features and Benefits
- SPEEDLAN 9200 Mesh Protocol -- How It Works in Mesh Cells
- Document Changes/Corrections
- Contacting Technical Support
- Rooftop and Tower Installations Warning
- Regulatory Information
- Declaration of Conformity for RF Exposure
- General Safety Requirements for Installation of SPEEDLAN 9200 Models
- Hardware Overview
- Drawings of Outdoor, Remote-Mounted Components
- The SPEEDLAN 9202/SPEEDLAN 9203/SPEEDLAN 9205 with External Antenna
- Manual Initial Configuration of the SPEEDLAN 9200
- Overview of the SPEEDLAN 9200 Configurator General Main Menu
- Logging on the SPEEDLAN 9200 Configurator
- Helpful Information to Know...
- The Configuration Menu
- Network Menu
- System Menu
- Routing Menu
- Configuring the Radio Parameters
- DHCP Server Menu
- Setting Up DHCP and DHCP Relay
- Forwarding Menu
- Three Features of NAT
- Firewall
- IP Sessions
- Diagnostics Menu (Troubleshooting the Network)
- Admin Menu
- Network Menu
- Wireless menu
- Admin Menu
- Basics of IP Addressing
- Basics of Routing
- Glossary for Standard Data Communications
- Glossary for Standard Data Communications
- Appendices (A-F)
- Changing the Router's Topology Mode
- SPEEDLAN 9200 Configurator Passwords
- Manufacturer Information
- Radio Approvals
- SPEEDLAN 9200 Technical Specifications
- List of Acronyms
- Channels for IEEE 5GHz OFDM (UNII upper band)
- 2.4GHz DSSS Channels 2.4GHz OFDM Channels
- Software License Agreement
SPEEDLAN 9200 User Guide Part # 34357-MNL Rev.03
3-47
• Known Clients: Click this button if you want to assign specific IP
addresses to specific client computers on a given subnet. This feature will
also enable you to allow or decline specific client requests. For more
information, see Adding a Known Client.
Adding a New DHCP Subnet
1 To add a new DHCP subnet, click Add Subnet on the DHCP page. The
following page will appear:
Figure 3-34: Adding a New DHCP Subnet
Notes: After you have added a subnet, you can click the IP address under the
"Ethernet/Mesh Net" Network section, as circled Figure 3-34 on page 3-47, which
populates the following information:
• Network
• Netmask
• IP Start
• IP End
• Default Gateway
Notes:
In most cases, if you use values that are compatible with the appropriate network, you
will only need to change a few values (e.g., the last octet of "IP Start" and "IP End").
When you define the range of IP addresses to be assigned, make sure you do not
include any of the static IP addresses that you have assigned on the network.