Specifications

RT9 Powershelf Rectifier Technologies

158-1806-01.doc

41 2-Mar-06

working. Once there is at least one additional entry in the ARP table, use the

following command to ARP an IP address to the unit:

arp -s 192.168.0.97 00-20-4a-xx-xx-xx

3. Open a Telnet connection to port 1. The connection will fail quickly, but the unit

will temporarily change its IP address to the one designated in this step.

telnet 192.168.0.97 1

4. Finally, open a Telnet connection to port 9999, and press Enter within three

seconds to go into Setup Mode. If you wait longer than three seconds, the unit will

reboot.

telnet 192.168.0.97 9999

5. Set all required parameters

Note: The IP address you just set is temporary and will revert to the default value

when the unit 's power is reset unless you log into the unit and store the changes

permanently. Refer to the chapter on configuration for instructions on permanently

configuring the IP address.







7.2.3 Configuring the Unit

The following section is excerpted from Lantronix "Embedded Integration Kit" Revision D 06/03/02,

Part Number 900-226.

You must configure the Lantronix Interface so that it can communicate on a network

with WinCSU-2 and communicate with the MiniCSU-2 unit via the serial port.

The unit’s configuration is stored in nonvolatile memory (NVRAM) and is retained

without power. You can change the configuration at any time. The unit performs a

reset after the configuration has been changed and stored.

7.2.3.1 Using a Telnet Connection

To configure the unit over the network, establish a Telnet connection to port 9999.

1. From the Windows Start menu, click Run and type the following command,

where x.x.x.x is the IP address and 9999 is the unit’s fixed network configuration

port number.

telnet x.x.x.x 9999 (Example: telnet 192.168.100.123 9999)

Note: Be sure to include a space between the IP address and 9999.

2. Click OK.

3. The Lantronix Universal Device Server window displays.

*** Lantronix Cobox Universal Device Server ***