User's Manual

February 2003
Rev. A
Page 41 of 47
10.3. Toolbar Commands
10.3.1. Start Session
This command discovers (broadcast) the units on the network. The application waits (discover
time) for replies from the units (AUs and SUs) and display a list of the units replied. The discover
time interval can be configured in the application configuration file.
Figure 10-2: Discover Window in Unit Manager Tool
Select one the units from the list, select a Login User and type the password. Finally press the
Login Button. The application starts a session with the selected unit and the unit configuration is
retrieved and displayed. As long as the session is active, the unit type, MAC address and IP
address are displayed on the title of the application window.
The Login settings can be saved in the application configuration file by checking the Remember
Setting Checkbox.
10.3.2. End Session
This command ends the session with the unit and the title of the application window is changed.
10.3.3. Refresh Unit Parameters
This command refreshes the displayed unit configuration by getting it again from the unit.
10.3.4. Auto Reconnect
When the Auto-Reconnect button is pressed and a session with a unit ends the application tries to
reconnect to the unit until a session is started. If the Logger was active before the session ended,
the Logger is started again.
10.3.5. Start Logger
Enables the output of log messages from the unit and printing to the log window and log file
(Admin user only).