User's Manual

February 2003
Rev. A
Page 45 of 47
Ø Link Type – select the appropriate link type: point-to-multi-point or point-to-point. (Admin
user only). In point-to-multi-point the output power (EIRP) will never exceeds +36dBm for
any antenna combination.
In point-to-point only EIRP can exceed +36dBm according to FCC 15.247(b)(4)(i). For the
24dBi antenna gain there is no limit of the output power and it can reach the max of
+18.5dBm.
This option is only allowed by password of administrator privilege and should be done by a
professional installer only!
When the configuration is updated it can be burned to the unit by pressing Submit. The Unit
performs reset and reconnect to it should be done in order to verify the changes.
10.5. Boot Window
The Boot Window displays the Boot Banks and the Active Boot Banks. Changes to the boot banks
can be done only by an Admin user.
The Boot Banks are used by the Boot Loader to decide which Firmware/PLD/PHY software should
be loaded. The Actual Boot Banks that show which Firmware/PLD/PHY software the Boot Loader
actually loaded.
After the software was burned and verified (Software Window), the boot bank should be changed
and burned by pressing Submit.
It is necessary to reconnect to the unit and verify that the burned software was loaded - the
Actual Boot Bank matches the Boot Bank. If the Boot Bank and the Actual Boot Bank does not
match, the image burned is corrupted and should be burned again.
Figure 10-5: Boot Window in Unit Manager Tool