User's Manual
Table Of Contents
- GigAccess™ OFDM 5.8
- Installation and Operation Instructions
- TABLE OF CONTENTS
- TABLE OF TABLES
- TABLE OF FIGURES
- Introduction
- Installation
- GigAccess™ OFDM 5.8 Technical Specifications
- Appendix A – WaveIP Approved Antennas
- Appendix B – RF Link Budget Calculation
- Appendix C – RF Power and Distance versus Antenna Gain
- Appendix D – RF Hazard Distance Calculation
- Appendix E – RF Channel List
- Appendix F – Outdoor Cables Scheme
- Appendix G - Using the Unit Manager Tool
WaveIP Ltd. GigAccess™ OFDM 5.8
Pa
g
e 21 of 41
2
2
.
.
7
7
S
S
u
u
b
b
s
s
c
c
r
r
i
i
b
b
e
e
r
r
P
P
C
C
S
S
e
e
t
t
u
u
p
p
In Case of specific IP setup
- Configure the PC NIC to the same specific IP address
as configured in the Base Controller. For this configuration follow the following steps:
• Press right click on the Network Neighborhood Icon.
• Select the Protocol reed and press properties.
• Choose the Specify an IP address and fill in the required specific IP address.
In Case of DHCP/NAT setup
- Configure the PC NIC obtain an IP address from
DHCP server. For this configuration follow the following steps:
• Press right click on the Network Neighborhood Icon.
• Select the Protocol reed and press properties.
• Choose Obtain an IP address from DHCP server.