User's Manual
Table Of Contents
- GigAccess™ OFDM 5.8
- Installation and Operation Instructions
- TABLE OF CONTENTS
- TABLE OF TABLES
- TABLE OF FIGURES
- Introduction
- Installation
- GigAccess™ OFDM 5.8 Technical Specifications
- Appendix A – WaveIP Approved Antennas
- Appendix B – RF Link Budget Calculation
- Appendix C – RF Power and Distance versus Antenna Gain
- Appendix D – RF Hazard Distance Calculation
- Appendix E – RF Channel List
- Appendix F – Outdoor Cables Scheme
- Appendix G - Using the Unit Manager Tool
WaveIP Ltd. GigAccess™ OFDM 5.8
Pa
g
e 39 of 41
Sensibility:
" Set the default value (threshold to cut RF noise level).
RF compression:
" For WaveIP technicians only. Do not mark the checkboxes.
RF attenuator:
" Add attenuation in the Rx path (reception). Good for increasing IIP3. Default
value is recommended.
When the configuration is updated, it can be burned to the unit by pressing Submit.
The Unit performs reset and reconnect to it should be done in order to verify the
changes.
1
1
0
0
.
.
6
6
S
S
o
o
f
f
t
t
w
w
a
a
r
r
e
e
w
w
i
i
n
n
d
d
o
o
w
w
The Software Window provides information of the burned software in the unit.
Figure
10-7: Software Window
The information contains the following fields:
" Bank – the bank number.
" Size – the size in bytes of the image burned in the bank.
" Version – the image version.
" Date – the image date.
" Time – the image time
" Checksum – the image checksum.
Note: The active boot banks are marked in yellow.
Note: value of ‘N/A’ in the bank’s field means that there is no software burned in this
bank.