User's Manual
Table Of Contents
- GigAccess™ OFDM 5.8
- Installation and Operation Instructions
- TABLE OF CONTENTS
- TABLE OF TABLES
- TABLE OF FIGURES
- Introduction
- Installation
- GigAccess™ OFDM 5.8 Technical Specifications
- Appendix A – WaveIP Approved Antennas
- Appendix B – RF Link Budget Calculation
- Appendix C – RF Power and Distance versus Antenna Gain
- Appendix D – RF Hazard Distance Calculation
- Appendix E – RF Channel List
- Appendix F – Outdoor Cables Scheme
- Appendix G - Using the Unit Manager Tool
WaveIP Ltd. GigAccess™ OFDM 5.8
Pa
g
e 40 of 41
1
1
0
0
.
.
6
6
.
.
1
1
F
F
i
i
r
r
m
m
w
w
a
a
r
r
e
e
W
W
i
i
n
n
d
d
o
o
w
w
The Firmware Window provides the ability to burn a new firmware to one of the banks
(Admin user only). The new software can only be burned to the alternate boot
Bank. The browser button is used to choose software for burning. When submitting
the burn operation, a progress window that shows the burning process appears. When
the burn process is done, the user is asked if switching banks is needed and whether
to reset the unit after the switch. After the reset, reconnect to the unit and check that
the software was burned (View the Software Window).
Figure 10-8: Firmware Window