August 2005 GigAccessTM OFDM 900Q SelfSelf-Install RSU User Guide
Table of Contents 1. INTRODUCTION ...........................................................................................................3 1.1. GENERAL .............................................................................................................................3 TM 1.2. GIGACCESS OFDM 900Q SYSTEM OVERVIEW ...................................................................3 2. PACKING LIST....................................................................................................
1. Introduction 1.1. General Congratulations on your purchase of the WaveIP GigAccess™ OFDM 900Q self-install Business/Residential Subscriber Unit (RSU). This document describes how to install and use your subscriber unit to obtain wireless high-speed Internet access. You can connect your RSU both to a computer and to a local area network (LAN) through the integrated two ports. 1.2.
2. Packing List When you first open the package, verify that the unit is complete and consists: • RSU Unit • Power Supply • Quick Start Guide Figure 2-1 illustrates the RSU package contents.
3. Installation Process 3.1. General The RSU is a self-installed, plug and play unit, which requires minimum operation from the user. A description of the RSU is given in the figure below. 1. Polarization Indication 2. Air link led (Green) 3. ETH link led (Yellow) 4. Received Signal Indicator Lights 5. ETH Connector 6. Power led 7.
3.2. Before You Start 1) Make sure your computer is equipped with an Ethernet Network Interface (NIC) 2) Make sure your computer is set up to automatically obtain an IP address (See 0). 3) Select the appropriate location for the RSU: • Make sure you are operating the RSU in a room near an outside window. • Locate the RSU in such a way that the antenna side will be directed towards your service provider (AU direction).
AU Direction RSU Power Supply 100-240V AC Ethernet Data Cable CAT5 Figure 3-2: GigAccess™ RSU - Installation Scheme 3.4. Radio Channel Selection The radio channel is defined at the AU side. The RSU is pre-configured to scan all channels. Therefore it will acquire the AU channel automatically. 3.5. User PC Setup Configure the PC NIC to obtain an IP address from DHCP server. For this configuration follow the following steps: • Press right click on the Network Neighborhood Icon.
3.7. FCC Information Notice: This device has been tested and found to comply with Radio Frequency Exposure Limits. A minimum separation distance of 30 cm must be maintained between the device in operation and all persons. This device complies with Part 15 of the FCC Rules.
4. GigAccessTM OFDM 900Q RSU Technical Specifications Operating Frequency 902 – 928MHz ISM band Number of Channels 21 (905 – 925) in step of 1MHz Access technology TDMA (Time division multiple access) Duplexing schemes TDD (Time division duplex) RF Waveform OFDM Raw Data Rates 6, 18 Mbps Data Throughput Up to 5.0 Mbps for RSU Radio Sensitivity @18 Mbps: -80 dBm, IE-2 PER1 @6 Mbps: -82 dBm, IE-2 PER EIRP 36 dBm (max) Antenna Gain 6.
