User's Manual

Page 7 of 7
AU Direction
Ethernet
Data Cable
CAT5
Power
Supply
100-240V AC
RSU
Figure 3-2: GigAccess™ RSU - Installation Scheme
3.4. Radio Channel Selection
The radio channel is defined at the AU side.
The RSU is pre-configured to scan all channels. Therefore it will acquire the AU channel
automatically.
3.5. User PC Setup
Configure the PC NIC to obtain an IP address from DHCP server.
For this configuration follow the following steps:
• Press right click on the Network Neighborhood Icon.
• Select the Protocol tab and press properties.
• Choose Obtain an IP address from DHCP server.
3.6. Safety
1. Do not immerse the equipment in any type of liquid.
2. Only operate the equipment from the power source(s) Supplied by Manufacturer! Any other
type of input power source may cause damage to the equipment and voids the warranty.
3. Do not place the equipment on an unstable surface.
4. Do not disassemble the equipment. Removing covers voids the warranty.
5. Do not expose the equipment to extreme hot or cold temperatures.