User's Manual
WaveIP Ltd.
WipAir Installation Guide
Page
15
of 28
2
2
.
.
3
3
.
.
4
4
A
A
l
l
i
i
g
g
n
n
m
m
e
e
n
n
t
t
Power up the unit:
1. Plug the Power Supply into a wall outlet or other standard AC power source.
This is only for use prior to permanent mounting, so any available wall outlet
in close proximity to your mounting location is suitable.
2. Connect the Outdoor-to-Indoor cable to the PoE ‘PWR LAN-OUT’ port (this port
supplies 48 VDC in addition to the Ethernet data).
WipAir is aligned using 2 methods:
2
2
.
.
3
3
.
.
4
4
.
.
1
1
U
U
s
s
i
i
n
n
g
g
t
t
h
h
e
e
L
L
i
i
n
n
k
k
M
M
a
a
n
n
a
a
g
g
e
e
r
r
1. Connect a CAT5 Ethernet cable from a PC to the PoE Outlet ‘LAN-IN’ port.
Note: Do not attach standard CAT5 cable from the Outdoor Unit directly to
the PC. Connecting the PC directly to the Outdoor Unit may cause
damaged to the PC Ethernet NIC.
2. Start Link Manager application.
3. Press the “Start Session” button (“S” symbol) and select the unit from the
popup address window.
4. Select “Installation” at the left menu tree.
5. Rotate the antenna for maximum RSSI with zero PER on the installation
window of the Link Manager. To avoid saturation, make sure the RSSI level
does not exceed –25 dBm.
Note: Do not stand in front of transmitting antenna. Rotate the antenna from
the rear side.
6. Mount and secure the unit by fastening the mounting screws.
2
2
.
.
3
3
.
.
4
4
.
.
2
2
U
U
s
s
i
i
n
n
g
g
t
t
h
h
e
e
b
b
u
u
i
i
l
l
t
t
i
i
n
n
R
R
S
S
S
S
I
I
b
b
u
u
z
z
z
z
e
e
r
r
WipAir units have a built in RSSI buzzer that indicates the best mounting location.
The buzzer is beeping at four tone levels:
• Fast – highest signal obtained so far.
• Medium – the current RSSI is lower than the highest signal obtained so far.
• Slow – the current RSSI is much lower than the highest signal obtained so far.
• No sound – no reception of the base station at all (or the buzzer is off).
To align the unit using the RSSI buzzer, please perform the following steps.
1. When the unit is first connected to power, the buzzer will be automatically
activated in one of the following modes:
• No sound – there is no reception.
• Fast beep – there is a reception (which is currently the maximum signal
obtained).
2. Set the MU at fixed modulation of BPSK ½ in both uplink and downlink.