User's Manual
WaveIP Ltd.
WipAir Installation Guide
Page
16
of 28
3. Take the unit to the selected location and align the antenna in the link’s
direction. Listen to the buzzer tone level. Any sound (fast, medium or slow)
indicates a reception.
4. Change and rotate the antenna to the left, right, up and down, scanning for
the maximum reception point.
5. After the scan is complete, align the antenna to the location where the buzzer
beeps at the fast rate, indicating the maximum reception.
6. Mount and secure the unit by fastening the mounting screws.
7. Set the MU back to adaptive modulation (AUTO) for both uplink and downlink.
8. Disable the RSSI buzzer.
To activate/deactivate the buzzer manually, use the Link Manager advanced window.
Note: During this procedure, do not disconnect the unit from power.
2
2
.
.
3
3
.
.
5
5
S
S
e
e
a
a
l
l
i
i
n
n
g
g
The outdoor unit must be sealed against rain with the rubber grommets.
RJ-45 ports of the outdoor unit must be facing down.
Note: All Units are factory sealed, seal needed only on Ethernet ports.
Opening the unit will void WipAir product warranty.
RJ-45 ports must be facing down. If installed to the side, the bending of
the CAT5 cable damages WipAir sealing and voids product warranty.