User Manual

Boomer II User Manual & Integrator’s Guide
________________________________
___________________
Test Jig
BM210012WT09 33 Wavenet Technology
<F2> Set Destination LLI
Similar to the above option, but sets the destination LLI for messages
sent by the "SEND MESSAGES" options.
<F6> Automatically Set SRC/Dest LLIs And Home Area
Automatically queries the modem for its LLI and home area, and sets
the above two options with that LLI for loopback tests, and the next
option with that home area address. This is easier than typing the LLI
for both source and destination options, and the destination address.
<F3> SYS Address
This option sets the default destination area for messages sent with the
"Send Messages" option. This value is saved in the initialisation file.
<F4> Compile NCL Message, or Send NCL Script
This option allows you to send any NCL command to the modem. For
example, by pressing <F4>, typing "4z" and then pressing <Enter>
will cause a command SDU to be sent to the modem asking for the
static channel table. To enter a non-ASCII value, use the form \7C
where the backslash indicates that the next two characters are to be
treated as a hexadecimal byte value (in this case 7C). This option is
only useful if you have a copy of the NCL specification to translate
commands into byte values.
RSUSER is also able to send commands taken from the definition file
rstest.def. This file contains a list of “scripts”, which contain
predefined commands. The comments in the sample rstest.def file
describe how to format the scripts in the file.
To send a script, press <F4>, and then type the script name prefixed by
the "=" (equals) sign.
For example, to run the "enablerx" script, press <F4>, and type
"=enablerx", followed by <Enter>.
<F5> Change Com Port Parameters
This option allows you to change the communications port settings
which RSUSER uses to communicate with the modem. You will be
asked for the port address and port IRQ. You will be given examples
for the common four PC com ports.
Note: You must exit from and restart RSUSER before these settings will
take effect.