User's Manual
Table Of Contents
- Introduction
- The Integrator’s Task
- Installing the Modem
- Using the Modem Test Jig
- Testing
- Desense
- Application Development
- Message Routing and Migration
- Appendix A - NCL Interface
- Appendix B - Software Development Kit
- SDK Contents
- System Requirements
- SDK Software Architecture
- NCL Application Programmer’s Interface
- Implementation
- Logical Architecture
- Application Interface
- Opening a Session
- Close Session
- Send Data to a Radio Host
- Receive Data From RPM
- Get RPM Status Information
- Set Configuration ITEMS Within the RPM
- Reset RPM
- Register Event Callback Function
- Enable / Disable Events
- Get Error Description
- Register Wakeup Application
- Deregister Wakeup Application
- Switch RPM On/Off
- Send Generic NCL Command To RPM
- Get Software Version
- SCR Application Programmer’s Interface
- A
- Appendix C – Sample programs
- Appendix D - Wavenet Application Loader
- Appendix E - Numeric Conversion Chart
- Appendix F - Specifications
- Appendix H - Glossary
Introduction ________________________________________________ Boomer II User Manual & Integrator’s Guide
Wavenet Technology 10 BM210012WT27
This manual contains the following sections:
Section 1: Introduction
Section 2: The Integrator’s Task
Section 3: Installing the Modem
Section 4: Modem Test Jig
Section 5: Testing
Section 6: Desense
Section 7: Application Development
Section 8: Message Routing and Migration
In addition there is very useful reference information contained in the
numerous Appendices which the reader may like to scan.
Features
The Boomer II OEM Modem is approximately the size of a credit card
and just 9mm thick. The modem is easily connected to many other
devices and can be incorporated into a variety of package formats. The
modem has a TTL serial port.
The Boomer II OEM Modem has the following features:
Serial communications interface port (TTL level)
running an NCL protocol
Indicator lights shows the status of the network coverage and
power supply
Four configurable digital input/output lines for external
control/monitoring
Software configurable RF calibration adjustments to suit
specific networks
High sensitivity reception
Small footprint and low profile design
Low-voltage and low standby current consumption for battery
based products
Auto-wake up of host on incoming messages
Roaming capabilities as used in DataTAC system
Modem is always online using the DataTAC network
Easy to install, service and update