User's Manual
Table Of Contents
- Introduction
- The Integrator’s Task
- Installing the Modem
- Using the Modem Test Jig
- Testing
- Desense
- Application Development
- Message Routing and Migration
- Appendix A - NCL Interface
- Appendix B - Software Development Kit
- SDK Contents
- System Requirements
- SDK Software Architecture
- NCL Application Programmer’s Interface
- Implementation
- Logical Architecture
- Application Interface
- Opening a Session
- Close Session
- Send Data to a Radio Host
- Receive Data From RPM
- Get RPM Status Information
- Set Configuration ITEMS Within the RPM
- Reset RPM
- Register Event Callback Function
- Enable / Disable Events
- Get Error Description
- Register Wakeup Application
- Deregister Wakeup Application
- Switch RPM On/Off
- Send Generic NCL Command To RPM
- Get Software Version
- SCR Application Programmer’s Interface
- A
- Appendix C – Sample programs
- Appendix D - Wavenet Application Loader
- Appendix E - Numeric Conversion Chart
- Appendix F - Specifications
- Appendix H - Glossary
NCL INTERFACE ___________________________________________ Boomer II User Manual & Integrator’s Guide
Wavenet Technology 124 BM210012WT27
Parameter length :
0x0001 (“Byte3Byte4”)
Parameter contents :
One unsigned byte (“Byte5”) indicating the Power
Save mode as follow:
ASCII ‘0’ : EXPRESS (Disabled
Power Save or “full awake” mode).
ASCII ‘1’ : MAXIMUM (4 windows).
ASCII ‘2’ : AVERAGE (8 windows).
ASCII ‘3’ : MINIMUM (16 windows).
Parameter name: WN_PROFILE
Parameter number :
0x6600 (“Byte1Byte2”) (ASCII 0x66 = ‘f’)
Parameter length :
0x0001 (“Byte3Byte4”)
Parameter contents:
One unsigned byte with the number of the new
active profile.
Parameter name: WN_MSG_RX_NOTIF_TMR
Parameter number :
0x6E00 (“Byte1Byte2”) (ASCII 0x6E = ‘n’)
Parameter length :
0x0002 (“Byte3Byte4”)
Parameter contents:
One unsigned word (2 bytes) containing the
number of milliseconds between message
notifications to the Palm. The maximum setting is
65 seconds (65000 milliseconds).